How to Change the Rubber Ring on a GE Front Load Washer
- 1). Unplug the washer from the wall to prevent electrical shock.
- 2). Remove the three screws from the bottom panel of the washer with a screwdriver. Pull the bottom panel off.
- 3). Loosen and remove the screws from the lid of the machine at the back of the unit then slide the lid forward to remove it.
- 4). Remove the screws from the back of the control panel. Depress the tabs on the panel and pull it forward.
- 5). Unplug the wires from the control panel by pulling on the connectors.
- 6). Remove the screws that hold the door latch in place.
- 7). Slide the screwdriver between the wire ring and the door seal.
- 8). Remove the four screws from the front panel of the washer. Lift up on the door panel to remove it from the washer.
- 9). Unscrew the band that holds the seal in place to loosen the band. Pull the seal from the washer.
- 10
Reassemble the washer by reversing the above instructions.
Source...