There are particular methods that are used for cutting melamine faced chipboard with the goal that it doesn't chip. Without the right sharpened pieces of steels or devices, chipping will happen. Melamine board is utilized for numerous diverse bureau parts-incorporating entryways, racks and drawers. A few shops utilize it for everything with the exception of the toe kick territories. In the event that you are reducing on a table saw, there are two alternatives you have for cutting the board with negligible chipping. You won't yield immaculately clean, without chip surfaces on both sides of the board unless you have a twofold bladed table saw. They usually take over fifteen-thousand dollars.

The principal strategy requires that you have a recently sharpen steel saw in your machine. You'll need to change your blade's sharp edge by the board that it just slices through the highest point of the board. Sharpen in on a couple of bits of Melamine before working with the true bureau making materials. Change the height of the cutting edge until you are getting a clean cut on both sides of the board. You may as well cut your material gradually through the cutter; the slower you cut, the fewer chips you will have. This is a unique table saw cutter that is intended for making clean cuts on both sides of Melamine board. This is not a shabby thing to add to your gathering of apparatuses. So assuming that you are set to just utilize it once, you may recognize doing something else.

You can stamp precisely where the blade sharp edge will be cutting melamine faced chipboard and afterward spot a piece of veiling tape over the range as an afterthought of the board that would ordinarily be chipping throughout the cut. This as a rule works pixie well. The grandest detriment to utilizing any tape is that the stickiness can make trouble when making your cuts. Be extremely cautious assuming that you choose to attempt this technique it is not extremely sheltered. There are numerous routes of concealing the chips as well. Assuming that you are cutting racks, you can put the chips either on the upwards or downwards sides so they can't be seen. Provided that you are manufacturing drawers out of the Melamine, you can verify that you place the clean cut side within the drawers. In the event that you are utilizing the material for pantry entryways, you may as well attempt to get the cleanest cut as would be prudent on both sides.