How to Hatch Chicks Without an Incubator
- 1). Using a utility knife, cut a 7-by-10-inch window from one side of a clean Styrofoam cooler or ice chest. Remove the glazing from an 8-by-11-inch picture frame. Tape the glazing securely over the hole from the inside of the chest with packing tape to create an incubator window.
- 2). Punch pencil-size air holes in the Styrofoam cooler or ice chest. Make three holes on the long sides and one on the short sides near the base of the cooler.
- 3). Using tin snips, cut a square piece of welded wire mesh that is equal to the bottom dimensions of the cooler. Make 3-inch, diagonal cuts at each corner of the square piece and fold down the flaps to create a stand.
- 4). Place the cooler in a warm location with minimal temperature fluctuations.
- 5). Line the bottom of the cooler with a heating pad. Thread the cord out of the cooler opening.
- 6). Place a small, shallow pan in the bottom of the cooler on top of the heating pad. Set a warm water-soaked sponge in the pan for humidity. Set the wire mesh stand over the pan.
- 7). Place a mini fan on the bottom of the cooler to one side of the mesh stand. Thread the cord out of the cooler opening.
- 8). Tape a thermometer to the wall of the cooler that is opposite the window.
- 9). Punch a small hole in the center of the lid. Thread the cord of a hanging or clamp light through the hole. Equip the lamp with a 15- to 25-watt bulb. Hang the cord above the cooler so it hangs at a height where the bulb hovers several inches above the mesh stand but not dangerously close to the Styrofoam. Tape around the cord with duct tape to block any gaps.
- 10
Close the lid of the cooler. Turn on the lamp and turn the fan and the heat pad to low. Monitor the thermometer and make any adjustments to create a controlled environment of around 100 degrees F. - 11
Set the eggs to be hatched on top of the mesh rack and keep them in the cooler for 21 days. Turn the eggs three times a day for the first 18 days. On the 18th day, place a piece of cheesecloth under the eggs to soak up residue from hatching. Re-soak the sponge regularly throughout the hatching process.
Source...