Bissell ProHeat Select Upright Cleaner Instructions
- 1). Vacuum the area to remove as much dirt and debris as possible before you use the ProHeat Select.
- 2). Remove the cleaning tank from the ProHeat base by lifting up on the handle. Lift the tank latch, and remove the top of the tank.
- 3). Fill the tank with hot water, and close the lid. Hook the tank lid to the bottom of the tank, and push the tabs into the grooves on the bottom of the tank. Secure the water tank back onto the cleaner base.
- 4). Pull the formula tank up from the back of the machine, and remove the cap. Fill the formula tank to the "Water" line, and then fill the remainder of the tank with cleaning formula to the "Fill" mark.
- 5). Place the formula tank back onto the unit. Set the "Custom Clean" dial to your desired setting, depending upon the level of cleaning needed. Set the "ReadyTools" dial to the correct floor type setting.
- 6). Connect the power cord to a power outlet. Turn the "Power" switch to "On," and the "Heater" switches to "On." Wait one minute for the unit to heat.
- 7). Press the trigger to send cleaning spray onto the floor surface, and push the ProHeat forward and back over the damp area. Release the trigger and pass again over the same area.
- 8). Turn the power and heater switches to "Off" when you are finished, and unplug the unit. Lift off the water tank, and empty it into a sink. Rinse the tank, and set it aside to dry. Remove the red filter from under the tank, and rinse it.
- 9). Remove the floor nozzle with a Phillips screwdriver, and rinse the nozzle. Hook the tabs back onto the machine, and screw it back into position. Wipe out the end caps of the brush rolls with a clean, dry cloth.
Source...