Prepare the fabric

• 1). Place the fabric right side up and iron it to remove any wrinkles.
  
  
• 2). Place the rounded disk portion of the button on top of the fabric scrap and use the marker to draw a circle around the button, keeping your marker approximately 1/2 inch from the edge of the button as you draw the circle.
  
  
• 3). Cut out the circle on the marked line.
  
  
• 4). Place the bowl shaped button maker on a flat work surface. The button maker is the part of the button form set that is made from flexible plastic and shaped like a little bowl.
  
  
• 5). Place the fabric circle wrong side up on top of the button maker. Make sure the fabric is centered over the button maker.
  
  
• 6). Insert the rounded disk portion of the button form into the button maker until it snaps into place, sandwiching the fabric circle inside.
  
  
• 7). Tuck all raw fabric edges over the back of the button and top with the button back.
  
  
• 8). Apply firm pressure to snap the button back into place. Remove the completed button from the button form.