How to Put an Airsoft Magazine Back Together
- 1). Hold, in one hand the magazine clip's inner sleeve, which contains the gear wheel-loading mechanism. Rotate the inner sleeve so that the gear wheel is at the bottom. Stand the inner sleeve on a table, with the end opposite the gear wheel facing up.
- 2). Hold the magazine clip's case with the open end facing down. Place the open end of the case over the top end of the inner sleeve. Push the case down onto the inner sleeve, until you can no longer see the inner sleeve.
- 3). Turn the case over. Rotate the case so that the slot, at one edge of the case, is facing right.
- 4). Hold the locking plate so that the hole at one edge is facing left. Insert the edge of the locking plate into the slot in the right side of the case.
- 5). Press the tip of a pencil or flat-edged screwdriver against the button on the left top side of the case. Push in the button. Slide the locking plate across the case to the left side. Release the button. Reload the magazine clip with the ammunition that the airsoft-brand weapon uses. Push the magazine clip back into the appropriate slot, at the bottom of the airsoft-brand weapon---typically this will be the butt of a handgun or just in front of the trigger guard of a rifle.
Source...