New Products Stop Worn Engine Oil Burning. Adds Years More Good Service
When your motor starts using a quart or two of oil between fluid changes, you know its getting time for some serious repair expense. The good news for you and your car or truck may be this.
Almost instance results and a renewed like-near-new performance. The above is also my experience. I've used the treatment in several hi-mileage, oil burning cars and it put a stop to their oil burning. Compared to the price for an engine overhaul, which may pass $3000. Mega Power cost a fraction of that amount. Its well worth a try, and cost nothing, if its not what ends your car oil burning problem. This new product sells for well under $100, and comes with a money back guarantee. Sold online. Details: [http://www.auto-tune-up-and-repair-options.com/worn-motor-treatment.htmlOil] burning ends here.
New products are available to end wear and performance problems like heavy oil usage. They are replacing the 40 year run of those thick, sticky, honey-like additives sold for that purpose. Those that part store clerks sold us for such problems.
The odd think about it is this.
We've been pouring thick, sticky, surpy additives in our motors, and never giving it a thought our motors were already choked up with sludge. And now, we're adding more thick gooey stuff into our motor for some reason that was suppose to stop oil burning - but seldom did!
The thinking with solvent type engine flushes is to use them to rinse-out the motor of its sludge. This was in hopes less sludge would somehow slow down the burning problem. It never did!
Those solvent based engine flushes removed sludge from one area and deposited it in other areas. Sometimes plugging up the motors oil delivery passage ways. That would starve those areas of the motor of oil. No good of course!
Solvent flushes has other negatives, too. They remove the oil film between our motors engine crank and bearings. Or, pistons and cylinder walls. This oil-film is suppose to keep motor moving parts lubricated and apart. I'm sure you heard the horror stories of engines suddenly failing after a solvent additive "stop leak," or engine flush was used.
More cars and trucks are running great 50,000 more miles past what former vehicles of 20 years ago could.
And oil usage is what we contend with at that mileage.
Even our cars catalytic converters can't rid the exhaust of the motors bad habit.
But, now, new products are stopping oil burning.
This treatment stops oil burning, often in minutes. This can be seen where blue oil exhaust smoke - the evidence of an oil burning condition, ends right after you install this treatment, and while you're watching.
Leading the way with such a product is a product called the Worn Motor Treatment.
Research has found oil burning is caused by wide wear gaps, sticky piston rings, and sloppy-worn valve stems and their bores. This is not news as we knew it for a long time.
For example, when wear on the piston and cylinder walls widen the thickness from half of a hairs thickness to that of 3 hair widths, oil becomes easily sucked up into the suction of your motor's piston down stroke and burns it. That is where it goes.
Oil can also be sucked down the valve bore - your motor has two to four valves per cylinder. Both sources of oil burning are no good!
3 for the top of the motor and 3 for the bottom of the motor, installed a week apart, ends the oil burning problem.
Each of the six performs a different function so that combined, oil no longer can pass into the upper piston area - to be burned. Exhaust pipe smoke stops too.
Which are thinner than oil, penetrate and clean where oil can't. This removes sludge and holds it in suspension for draining. Freeing sticky piston rings ends another cause of oil burning. Then the product layers a coating over the worn areas to close down cylinder gaps.
That advantage plus one that conditions the oil to seals better on cylinder walls and valve stems, control the last cause of oil disappearance.
Almost instance results and a renewed like-near-new performance. The above is also my experience. I've used the treatment in several hi-mileage, oil burning cars and it put a stop to their oil burning. Compared to the price for an engine overhaul, which may pass $3000. Mega Power cost a fraction of that amount. Its well worth a try, and cost nothing, if its not what ends your car oil burning problem. This new product sells for well under $100, and comes with a money back guarantee. Sold online. Details: [http://www.auto-tune-up-and-repair-options.com/worn-motor-treatment.htmlOil] burning ends here.
Source...