Water Flow

• When mounting a transducer on your boat it is important to make sure that the transducer will receive a consistent water flow. The water flow allows the transducer to send out its sonar signal and then receive information back from the signal. If the water flow is obstructed, the signal will come out faulty and you may receive false information about the location of the fish. A good place to place your transducer is slightly to the left or right of the center of the boat's hull, toward the back of the vessel.
  
  

Angle

• To maximize the abilities of the transducer it is also recommended that you install the transducer pointing straight down into the water.
  
  

Hauling

• When you are hauling your boat on a trailer, your transducer may become vulnerable to being hit or damaged. To avoid this, make sure that the transducer is installed in a spot that will not come in contact with your trailer or engine. It is recommended that you install your transducer at least one foot from the engine.
  
  

Wiring

• You should also keep the transducer wiring away from the other wiring on the boat. Noise from the wires of the engine, pumps and aerators can interfere with the transducer's readings of the fish in the water.
  
  

Setting Up the Mount

• Most transducers come with mounting templates. Prior to mounting your transducer, hold the mounting template to the spot you want to mount it on, and then use a pencil to outline the mounting template.
  
  

Mounting the Transducer

• Though your transducer will use screws to attach to your boat, you should also use silicone sealant to help secure the transducer. Prior to screwing in your transducer, apply a coat of silicone sealant to the mounting holes on your transducer.